CCalclabhub

Everyday Life · 59 calculators

Plant Spacing Calculator

Plant spacing tells you how many specimens will fit neatly into a bed and how far apart to set them. By dividing the bed's length by the in-row spacing and its width by the between-row spacing, you get the number of plants per row and the number of rows. Multiplying those two figures gives the total plant count, while the bed area follows from length times width.

Total plants

80

Bed area
320
Plants per row
10
Number of rows
8

Values update as you type. This calculator covers the single scenario its formula assumes — see Common Mistakes for what it leaves out.

The formula this calculator uses

Total plants = (length ÷ in-row spacing) × (width ÷ between-row spacing)

L
Length of the bed along each row
W
Width of the bed across the rows
s
In-row spacing between neighbouring plants
r
Between-row spacing separating adjacent rows

How to check the result by hand

  1. 1

    Measure the bed in one consistent unit

    Record the length and width using the same unit, such as metres throughout. In the worked case the bed is twenty metres long and sixteen metres wide. If your spacing advice is given in centimetres, convert it to metres before doing anything else.

  2. 2

    Choose the two spacings

    Pick the in-row spacing from the mature size of the crop and the between-row spacing with access in mind. The default uses two metres for both. A crop that spreads widely may need a wider figure along the row, while paths between rows can push the other figure up.

  3. 3

    Work out plants per row

    Divide the bed length by the in-row spacing. Twenty divided by two gives ten plants in each row. If the answer is not a whole number, round down to the nearest whole plant so that you never count a fraction of a specimen.

  4. 4

    Work out the number of rows

    Divide the bed width by the between-row spacing. Sixteen divided by two gives eight rows. Allow a little extra width at the edges if plants would otherwise overhang a path or border.

  5. 5

    Multiply for the total and check the area

    Multiply plants per row by the number of rows to get the total, here ten times eight equals eighty plants. As a cross-check, multiply length by width to get the area of 320 square metres and divide by the four square metres allowed per plant, which again gives eighty.

Common Questions

How does the Plant Spacing Calculator work?

Plant spacing is worked out by dividing the length of the bed by the distance between plants within a row to get plants per row, and dividing the width by the distance between rows to get the number of rows. The product is the total number of plants. The bed area is simply length multiplied by width, and dividing the area by the space allocated to each plant gives the same total.

What do I need to enter in the Plant Spacing Calculator?

It takes 4 inputs: Bed length, Bed width, Between-row spacing, In-row plant spacing. Fields that expect a unit say so next to the label.

Where does Total plants come from?

It comes from P = L ÷ s — divide the length of the bed by the spacing between neighbouring plants in a row to find how many plants fit along that row.

What is the most common mistake with the Plant Spacing Calculator?

Mixing units between the bed and the spacing. Measuring the bed in metres while the seed packet gives spacing in centimetres or inches produces a wildly wrong count. Convert every measurement to one unit before dividing, and remember that a centimetre is one hundredth of a metre.

For worked examples, common mistakes and the limits of this formula, read the full How To Calculate Plant Spacing page.